PDA

View Full Version : looking for O rings


Red-Sea
December 4th, 2003, 11:17 PM
Hi guys/gals, just wondering if anyone knows where to purchase some O rings for Calcium reactor or Skimmer, the size I'm looking for is around 5-6" diameter. Any help would be greatly appriciated. :thanks: ..
Mckitrick
December 5th, 2003, 12:57 AM
Do you need O-Rings or can you use flat rubber gasket material and cut it yourself?
Red-Sea
December 5th, 2003, 01:17 AM
It has to be rounded Paul, any suggestions?
Michael_Lambert
December 5th, 2003, 01:34 AM
Large Elastics would not work?
tyrisis
December 5th, 2003, 01:50 AM
I needed an odd size oring for a power washer once and you can match them up at parts stores for the size you need... I could find the name of the place i used in hamilton if you need it.. but you should be able to find something closer..

Tyson
Daniel Schubert
December 5th, 2003, 06:18 AM
Pioneer Pools has a variety of large size O-rings, you may want to check them out
visor
December 5th, 2003, 10:11 AM
i need to see the o ring to match it up .their is a company in oakville that make o rings.
Mckitrick
December 5th, 2003, 04:34 PM
Red-Sea - It's been a few YEARS since I've been there but Active Surplus in downtown Toronto (not too far from you) had a pegboard with lots of different O-Rings on it.

The way Active is, they may no longer have this but it's worth calling them or popping in if you find yourself downtown...
Red-Sea
December 5th, 2003, 05:54 PM
Thx guys I'll check Active next week, I called Pioneer pools they don't have anything bigger than 3" diameter.
Mugster
December 5th, 2003, 06:05 PM
There's a place here in town, Rubber-Line I think it's called, the same place I bought my Loc-Line from, that I think carries large diameter o-rings. I'll pop in tomorrow morning and have a look. I was going there anyway to pick up some different nozzles for my Loc-Line returns.

Kev
Red-Sea
December 5th, 2003, 06:10 PM
Thanks Kev... :thanks:
barney76
December 5th, 2003, 06:29 PM
There is a place on Steels near PineValley Dr. called ABEL O-Ring.

They might have what you looking for,but if not they can make it for you.

Good luck
Mckitrick
December 5th, 2003, 08:47 PM
Hey Kev, Where's that place? I need a few locline nozzles..
Mugster
December 5th, 2003, 08:53 PM
Originally posted by Paul_BB_Guy
Hey Kev, Where's that place? I need a few locline nozzles..


It's on Bleams Rd just down from Budd Automotive. Go into the parts counter and you'll see a display of everything they carry.

Kev
Mckitrick
December 5th, 2003, 08:57 PM
Rubberline Products Ltd
81 Bleams Road
Kitchener, ON
N2C 2G2
Phone: (519)894-0400

Thanks Kev!